Bilge alarm 4 programmable zones wireless

Installation manual

Alarm with programmable microprocessor for detecting water ingress in boats.

Detecting a leak in time gives you many possibilities to save the boat and preserve the safety of your crew.

Simple connection does not require installation, the sensors work with a battery, they do not need cables, and the Display/CPU has 2 positive and negative connections at 12 Volts and an extra output to connect an external acoustic warning.

4-zone wireless alarm, the sensors work with a 12v A23 battery and the display is connected to 12 volts, they have no moving parts so it is difficult for them to break down, it is installed in the areas where water can enter, bilge, bottom taps, drains, horn, etc.

Programmable from the Android App, you can change the name of the zones, maximum 10 characters, Zone1 for example: stern taps, and so on the other zones, for easy and quick identification.

Operation:

When connected, it performs a test of the acoustic alarms and begins to monitor the zones.

Every time one of the 4 sensors detects the presence of water, with a delay of 5 seconds to avoid false alarms, it will activate the acoustic alarm inside the display and outside if an acoustic alarm is connected, and the programmed zone will appear (example stern taps),

This will cause an immediate response where the water inlet is originating, and so on with the following alarm zones, they will be displayed one after the other.

You can silence the alarm, or reset it and it will start monitoring all the zones again.

Connections:

CPU/Display: 12 Volts

Sensors: RF. 12v A23 long-lasting battery

Dimensions:

CPU/Display: 12x8x3 cm

Sensors: 6x5x2 cm

Includes:

4 sensors, batteries are not included

CPU/Display